5
METEOR 120-RGB
wire color
FUNCTION
Red
+ DC Power Supply
Black
GND Power Supply
Orange
+ Control
Brown
GND Control
Remote control connection
To control the mode of lighting the simple key-switch (not included) has to be used and connected to
the CONTROL wires by the 2-pole signal cable (not included).
CONTROLS
Remote control has to be used to turn-on and turn-off the underwater
pool light and to control the mode of lighting and luminosity.
The multi-color underwater pool light can be controlled by using the
key-switch.
When the light is turned-off
the color or mode of lighting can be
changed sequentially by pressing the momentary switch for 2
seconds:
METEOR 120-RGB
Sequence of lighting
Custom Color
Full RGB
Cool White
Bluish White
Red
Green
Blue
Rainbow Color Spectrum
5
230V AC
Puls-dim
controller
LED 12-24V
Power-
Supply
Earthing
The underwater pool light has to be earthed by using a pre-tinned green wire with a yellow stripe a
minimum of 8 AWG (8.36 mm
2
). The wire has to be connected to the underwater pool light by the
help of one fixing screw 5.5x38.
Connection
The power supply has to be connected through the main switch (not included) with correct polarity
and protected by a fuse (not included). The power supply voltage has to be from 10 - 30Vdc.
Note:
The power supply has to be switched off before installation.
The underwater light has to be connected as described in the table below
:
