33
Seeing the messages below means that Test Mode has failed to start. Check the solutions and try again.
Message
Solution
Could not access to Studuino
Make sure Studuino is connected to the PC.
Make sure your USB cable is properly
connected to your PC and Studuino.
Could not access to Studuino
Serial port already in use. Try quitting any
programs that may be using it.
Close any applications that may be
communicating with your Studuino.
If no other applications are communicating with
the board, unplug the USB cable and press the
onboard Reset button.
Pressing the RESET button on the Studuino board while in Test Mode will cause the connection between
your Studuino and PC to be interrupted and the message below to appear.
Message
Solution
Could not acces to Studuino
Communication terminated. Close Test mode,
reconnect your Studuino to your PC, reset your
Studuino and restart Test mode.
While you can continue programming once
you’ve closed Test Mode, we recommend
following the message and restarting the
software due to the resulting unstable
connection.
Push-buttons send a value of
1
when released and a value of
0
when you press them.
Try pressing buttons A0-A3 on your Studuino and see how the values respond in the Sensor Board.
Once you’re finished, choose
Test OFF
from the
Run
menu to close Test Mode.
The value will change to 0