Arris Moxi HD, User Manual

Page: 127 / 152

Setup Without CableCARD
Channel Scanning
If you set up a Moxi HD DVR without a CableCARD inserted, you’ll be asked during the onscreen setup process to conduct a scan for tunable channels. If
you need to perform a channel scan at a later time because you do not have any program information data, you can initiate one by going to Settings, Channel
List, selecting Channel Scan, and pressing OK. If you’re in the middle of onscreen setup:
1. Select Begin Scan by highlighting the button and pressing OK on the Moxi remote. The scan can take around 20 minutes.
2. When the scan is complete, select Restart by highlighting the button and pressing OK on the Moxi remote.
3. Some tunable HD channels in your lineup, discovered during the channel scan, may not match the electronic program guide (EPG) due to the way cable
service providers choose to list them. Moxi refers to the channels with incorrect or missing data as “unmapped”. To map them, go to Settings, and choose
Channel List. Select the Channel Mapping option.
Channel Mapping
In the Moxi Menu, navigate to Settings, and then select the Channel List option.
If there are unmapped tunable channels, the Channel Mapping card appears. When you select it, the vertical list will display all tunable channels that were not
associated with an EPG channel at the time of your channel scan. To map these channels:
1. With About Channel Mapping in center focus, press OK, and select Map All. This will map all of your analog channels.
2. For the remaining unmapped channels, navigate an unmapped channel into center focus. Press the right arrow and then use the up/down arrows to
review the list of available unassociated EPG channels.
3. Determine which unmapped EPG channel applies to an unmapped scanned tunable channel by reviewing the current programming information presented
or by watching the channel. When you find a match, press OK on the EPG channel and respond to the Map This Channel? confirmation. The channel will now
display in the list as a mapped channel.
4. If you determine that you mapped an EPG channel to a tunable channel in error, from the Channel Mapping card, navigate to the mapped channel, press
OK, and respond to the confirmation, Un-map this channel? Follow procedures in the steps above to map the channel correctly.
Configuration Alternatives
121