© 2013 Armored Fitness Equipment, LLC
Page 5
3.
Locate and remove the two bolts,
nuts, and washers, pre-inserted in the
rear axle tabs.
4.
Join the rear axle assembly and the
front wheel/fork assembly by inserting
the forks between the rear axle tabs,
lining up the bolt holes as shown.
The motor and the handle stubs
should be facing up.
If necessary, use a rubber mallet or
block of wood to gently tap the
forks/front wheel assembly into
alignment.
Use care not to use a
hammer or other object that could
chip or damage the powder coat
finish
.
5.
Insert one washer over each bolt and
insert the bolts in the holes, putting
them through the rear axle tabs and
the fork assembly. Be sure to insert
the bolts completely through the
holes, lightly tapping as necessary to
fully insert the bolt.
Place another washer over the end of
the bolt, followed by a nut. The nut is
rounded off on one side. The flat side
of the nut should be placed against
the washer, and the rounded side
should face outward.
Tighten firmly. Do not over-tighten.
