Armfield Instruction Manual
10
‘High Conductivity’. If measured values will not exceed 5 mS/cm then the Low
Conductivity input can be used to improve accuracy.
Fit the conductivity probe and temperature sensor to the appropriate gland on
the lid of the CEM-MKII reactor ensuring that they reach the bottom of the
reactor. The gland nut should be loosened prior to fitting the probe / sensor
then tightened to secure them.
CEXC fitted with CEM MkII Continuous Stirred Tank Reactor
Connection to the Hot Water Circulator
Connect return pipe of the HWC (1) to the connection for the top of the coil
(rear).
Connect the supply pipe of the HWC (2) to the connection for the bottom of
the coil (front)
Connection to Electricity Supply
Check the voltage specified on the equipment matches the supply voltage.
Note:
this unit must be earthed.
