DSTREAM-XT Getting Started Guide
Document ID: 102443_1.0_00_en
Version 1.0
Set up your DSTREAM-XT system
6. Power up the target hardware.
• When the DSTREAM-XT system is powered-up, ensure that the air intakes
on the top of each unit are free from any obstructions.
• If the DSTREAM-ST unit overheats, it shuts down, all the LEDs turn off, and
it remains in a safe state.
• If the XT probe overheats, it enters a low-power mode and all of its LEDs
flash red.
• To re-initialize the DSTREAM-XT system, press the
reset
button on the rear
of the DSTREAM-ST unit.
Next steps
• The first time you connect and power-up your DSTREAM-XT system you must
•
Related information
on page 12
DSTREAM-XT system boot sequence
on page 30
3.4 DSTREAM-XT system boot sequence
When you power up the DSTREAM-XT system, it goes through a boot sequence. The LEDs
identify the progress of the boot sequence.
The boot sequence is:
1. To indicate that both units are powered, the DSTREAM logo of the DSTREAM-ST unit
illuminates
blue
and the
STATUS
LED of the XT probe illuminates
red
.
2. The
FLASH
LED of the DSTREAM-ST unit flashes as it loads its firmware.
3. The
STATUS
LED of the XT probe illuminates
green
, indicating that its FPGA has successfully
loaded.
4. The
STATUS
LED of the DSTREAM-ST unit flashes
green
, and then stays illuminated, indicating
that it has successfully booted.
5. The
Host Link
LED of the XT probe flashes
blue
, and then illuminates
green
to indicate that the
units have successfully linked.
The DSTREAM-XT system is now ready for use.
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page
30
of
38
