DSTREAM-XT Getting Started Guide
Document ID: 102443_1.0_00_en
Version 1.0
The DSTREAM-XT system
Indicator LEDs on the top
When you power up the DSTREAM-ST unit, the LEDs on top of the unit indicate the status of the
unit.
Figure 2-17: Indicator LEDs
DSTREAM logo
The DSTREAM logo on the top of the unit illuminates and the
STATUS
LED begins to flash
when you power up the DSTREAM-ST unit. The DSTREAM logo also flashes when you
click the
Identify
button in the
Debug Hardware Configure IP view
in Arm Development Studio.
STATUS
Illuminates
green
to show that DSTREAM-ST is in its ready state.
If a critical error is detected, the
STATUS
LED illuminates as continuous
red
. If the
STATUS
LED is red, then you must reset the DSTREAM-ST unit to the factory settings before you can
continue using it. If the DSTREAM-ST unit fails to boot after a reset,
.
For more information, see
FLASH
Illuminates when the unit is accessing its internal flash storage.
TARGET
Illuminates when a valid target VTREF is detected.
DEBUG
Illuminates when debug data transfer takes place.
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page
19
of
38
