DSTREAM-XT Getting Started Guide
Document ID: 102443_1.0_00_en
Version 1.0
Set up your DSTREAM-XT system
• You must have the following items from the
:
◦ The DSTREAM-ST unit.
◦ The XT probe and the 60-way AUX cable.
◦ The power supply unit, dual DC power cable, and the mains cable that is appropriate for
your region.
◦ To connect the DSTREAM-ST unit to the host computer or the network, you need either:
▪ The USB cable, to connect the DSTREAM-ST unit directly to the host computer using
the USB 3.0 port.
▪ The Ethernet cable, to connect the DSTREAM-ST unit to the network.
◦ To connect DSTREAM-XT to the target hardware, you need a target-compatible cable/
adapter. For a list of supplied cables and adapters, see
• If DSTREAM-XT or the target hardware are not earthed, potential differences
can occur between them. During connection, potential differences cause
unwanted pulses in the debug interface. This might cause unwanted resets to
• Ensure the target connector has a compatible pinout before use. Incorrect
connections might damage the debug or target hardware.
Procedure
1. Connect the DSTREAM-ST unit, the XT probe, and the power supply unit:
a) Connect the DSTREAM-ST unit to the XT probe using the 60-way AUX cable.
b) Attach the Power Supply Unit (PSU) to the PSU-adapter end of the split power supply
cable.
c) Attach one end of the split power supply cable to the DSTREAM-ST unit, and attach the
other end to the XT probe.
2. Connect the DSTREAM-ST unit to the host computer:
• If you are connecting using the USB port, connect the DSTREAM-ST unit to the host
computer using the supplied USB 3.0 cable.
The USB drivers are provided with Arm Development Studio. For more
information, see the USB driver installation topics:
for the DSTREAM-XT system on Windows
Install the USB drivers for the
• If you are connecting across an Ethernet network, connect the DSTREAM-ST unit to the
local network using the supplied Ethernet cable.
Copyright © 2021 Arm Limited (or its affiliates). All rights reserved.
Non-Confidential
Page
27
of
38