Setting up your System
2-2
© Copyright ARM Limited 1999. All rights reserved.
2.1
Setting up your ARM development board
The ARM710T header card plugs into the top left hand corner of the development
board, with the ARM logo on the silk-screen positioned as shown in Figure 2-1, so that
the header is flush with the development board. The correct way to mount the header
card is shown in Figure 2-1.
Figure 2-1 Mounting the header card
The ARM710T can be debugged using one of the following:
•
Multi-ICE debugging system (available separately)
•
EmbeddedICE debugging system (available separately)
•
Angel debug monitor (supplied with the ARM development board).
Note
EmbeddedICE can be used to debug an ARM710T but does not support debugging with
the caches on.
ARM logo
ARM
development
board
ARM710T
header card
