5
OPERATION
Control Panel
1. Power indicator
2. Fan operation indicator
3. Cooling operation indicator
4. Full water indicator
5. Thermostat
6. Function switch
(options for low fan - high fan -
low cool - high cool)
7. Timer
(1-8 hours and ON/OFF function)
Turning ON/OFF
• Set Timer to ON for continuous
operation. Power indicator will
illuminate.
• To switch unit off turn Timer to OFF
position. Power indicator will dim.
Important Note: To prolong the
life of the compressor, wait for at
least 3 minutes before turning on the
unit, after it has been switched off.
Setting Timer
Set the Timer to the desired operating
time (1 to 8 hours). When the set time has
been reached the unit will shut off auto-
matically.
Setting Function
Turn the switch to the desired setting:
Low Fan - High Fan - Low Cool - High
Cool
Setting Temperature
Turn the thermostat to regulate the
desired temperature from 18 to 32
o
C.
Maximum cooling is obtained when knob
is rotated to fully clockwise position.
NOTE: The cooling system (compres-
sor) will switch off when the ambient
temperature becomes lower than the
preset temperature. The fan however
will continue to operate normally.
Regulating air flow direction
To control the air flow direction via the
vertical louvers rotate the central lever
at the bottom of the grille.
To control the air flow direction via
the horizontal louvers adjust louvers
manually (louvers interlocked).
DRAINAGE
During the cooling process some of the
water will be extracted from the air into
the unit. When the water inside the unit
reaches a preset level the compressor will
stop and only the fan will operate. The
Full Water
indicator will illuminate. To
reset the unit for normal operation, drain
the water using one of the following
methods:
Drain Tray
1. Turn off the unit when the Full Water
indicator illuminates.
2. Position the supplied water tray flat on
the floor, beneath the drain hole.
3. Remove the drain cap and rubber plug
from the drain hole, allowing the water
to drain out.
4. When the drain tray is almost full
replace the rubber plug into the drain
hole and empty the tray.
CPIN_518-2 15/9/04 5:08 PM Page 5