Arjohuntleigh NIMBUS, Instructions For Use Manual

Page: 19 / 32

13
To Reset CPR
To reset the
Nimbus Pediatric
System after the CPR has
been activated:
1. Push the CPR plugs fully into the holes in the side
of the mattress.
2. Close the CPR cover flap using the Velcro
provided.
3. Ensure that the CPR Tag hangs freely from the CPR
cover flap.
Patient Transport
The patient may be transported on the
Nimbus Pediatric
System as follows:
1. Turn the transport facility on the tube-set to
transport. The pressure in the two sets of cells will
be maintained and the patient will continue to be
supported for up to 12 hours with the patient in the
supine position.
2. Turn the pump off and disconnect the tubeset from
the pump.
To resume normal operation, re-connect the tube-set to
the pump, switch the pump on and turn the transport
knob to normal.

If the tube-set remains connected to the pump when the transport control is
set to transport, the pump will indicate a low pressure fault.

To obtain the maximum use of the transport facility ensure that the patient
remains in the supine position and the mattress is put in transport mode when
all cells are inflated.