Service Procedures
19
0
0
1
.1
60
1
0.
3
3 re
v
. 8
Drum Replacement
Required tools:
•
Retaining ring pliers
1. Refer to "Main Plastic Cover Replacement” on page 9 to remove plastic covers.
2. Refer to “Pass Through Hook Replacement” on page 11 to remove the Pass Though Hook
3. Refer to “Strap Inlet Replacement” on page 11 to remove the strap inlet.
4. Refer to “Main Circuit Board Replacement” on page 13 to remove the main circuit board.
5. Remove the snap ring that maintains the drum shaft with
retaining ring pliers. Remove the shaft.
6. Remove the snap ring that maintains the strap roll shaft with
retaining ring pliers. Remove the shaft and the strap roll.
7. Remove the drum.
8. Route the strap through the opening on top of the frame.
Insert the new drum into the frame then insert the shaft to
maintain it. Apply food type grease (PN P8100) over the gear
(2 - 3 g).
9. Insert the snap ring to secure the shaft.
10. Reinsert the strap roll then insert the shaft through it. Make
sure that the strap is behind the strap roll. Put the snap ring
back to secure the shaft.
11. Reinstall the circuit board as per “Main
Circuit Board Replacement” on page
13.
12. Refer to “Strap Inlet Replacement” on
page 11 to reinstall the strap inlet.
13. Refer to “Pass Through Hook
Replacement” on page 11 to reinstall
the pass through hook.
14. Refer to "Main Plastic Cover
Replacement” on page 9 to reinstall the plastic covers.
