Service Procedures
11
0
0
1
.1
60
1
0.
3
3 re
v
. 8
Fuse Replacement
Required tools:
• None
1. Refer to “Batteries Replacement” above to access the fuse
holder.
2. Pull out the fuse holder and open it (unscrew both parts) to
access the fuse.
3. Remove the fuse and replace it with a new one
(PN C8FGMA10).
4. Reinstall the fuse holder.
5. Reposition the fuse wiring as close as possible to the PCB
to prevent it from interfering with the cover when putting it back.
6. Refer to "Main Plastic Cover Replacement” on page 9 to reinstall both plastic covers.
Pass Through Hook Replacement
Required tools
•
Retaining ring pliers
1. Refer to "Main Plastic Cover Replacement” on page 9 to remove the plastic covers.
2. Locate the Pass Through Hook and remove the retaining
rings, placed on each sides of the handle, with appropriate
pliers.
3. Remove both plastic bushings and remove the handle.
4. Install the new handle by first inserting the longest shaft
into the hole.
5. Reinstall both bushings.
6. Insert the retaining rings on each side of the handle.
Make sure that the rings are in place and safely
retaining the handle.
7. Refer to "Main Plastic Cover Replacement” on page 9 to reinstall the plastic covers.
Strap Inlet Replacement
Required tools:
• Screwdriver
Torx
T20
•
Retaining ring pliers
1. Refer to "Main Plastic Cover Replacement” on page 9 to
reinstall the plastic covers.
2. Refer to “Pass Through Hook Replacement” above to
remove the handle (Pass Through Hook).
3. Remove both screws on the strap inlet with a Torx T20
screwdriver.
4. Replace the new strap inlet and fix it in place with the
screws on each side.
5. Refer to “Pass Through Hook Replacement” above to
reinstall the handle.
6. Refer to "Main Plastic Cover Replacement” on page 9 to reinstall both plastic covers.
Retaining Clip
Bushing
