Arjohuntleigh Alenti, Instructions For Use Manual

Page: 30 / 64

30
To bed - laying down (19 steps)
1 Drop the bed rail and apply the wheel
brakes on the bed.
2 Place a towel on the bed to avoid making
the bed wet from the
Alenti seat, if com-
ing from a bath.
3 Adjust the Alenti height to where the seat
and genitals clears the bed.
4 Move the front of Alenti over the bed and
grab the resident’s legs and lift them onto
the bed.
(See Fig. 1)
5 Active the Alenti brakes and ensure that
they are locked.
Lower Alenti so that the seat gets pressed
firmly on the bed. Make sure no body
parts get pinched between the seat and
bed.
7 If needed, raise the head end of the bed to
support the resident’s back.
(See Fig. 2)
8 Take of the safety belt and attach the
safety belt clip to the hand rest-handle
arm.
9 Lean the resident forward and place the
resident’s hands on the hand rest.
WARNING
To avoid falling during transfer,
always ensure that the brakes are
applied on all equipment being
used.
6
WARNING
To avoid entrapment or pinching
of genitals, make sure there is
enough clearance during move-
ment over the tub edge, toilet,
bedpan or other furniture.
10 Fold back the back rest-handle arm,
away from the resident.
11 Assist the resident to lean back against
the bed.
12 Fold back the hand rest-handle arm.
13 If the head end of the bed has been raised,
lower it back down.
14 Make sure the resident lays down flat on
the bed before turning him or her to their
side away from
Alenti and its seat.
(See Fig. 3)
15 Raise the Alenti seat to separate it from
the bed.
16 Release the Alenti brakes.
17 Move the Alenti away from bed.
18 Roll the resident from the side to his or
her back.
19 Pull the bed rail up.