16
Guidance and Manufacturer’s Declaration – Electromagnetic Immunity
The
Battery Charger
is intended for use in the electromagnetic environment specified below. The customer or the
user of the
Battery Charger
should assure that it is used in such an environment.
Immunity test
IEC 60601
test level
Compliance
level
Electromagnetic environment – guidance
Conducted RF
IEC 61000–4–6
3 Vrms
150 kHz to
80 MHz
3 Vrms
Portable and mobile RF communications equipment
should be used no closer to any part of the
Battery
Charger
, including cables, than the recommended
separation distance calculated from the equation
applicable to the frequency of the transmitter.
Recommended separation distance
d=0.35√P
d=1.2√P 80 MHz to 800 MHz
Where
P
is the maximum output power rating of the
transmitters in watts (W) according to the transmitter
manufacturer and
d
is the recommended separation
distance in metres (m).
Field strengths from fixed RF transmitters, as
determined by an electromagnetic site survey,
a
should be less than the compliance level in each
frequency range.
b
Interference may occur in the vicinity of equipment
marked with the following symbol:
Radiated RF
IEC 61000–4–3
3 V/m
80 MHz to
2.5 GHz
3 V/m
a)
Field strengths from fixed transmitters, such as base stations for radio (cellular/cordless) telephones and land
mobile radios, amateur radio, AM and FM radio broadcast cannot be predicted theoretically with accuracy. To
assess the electromagnetic environment due to fixed RF transmitters, an electromagnetic site survey should be
considered. If the measured filed strengths in the location in which the
Battery Charger
is used exceeds the
applicable RF compliance level above, the
Battery Charger
should be observed to verify normal operation. If
abnormal performance is observed, additional measures may be necessary.
b)
Over the frequency range 150 kHz to 80 MHz, field strengths should be less than 1V/m.
