Arjo Joerns Voyager, Instructions For Use Manual

Page: 18 / 32

Care and Maintenance
18
00
1.
08
07
5.
04
re
v.
13
Cleaning the Lift
Removing visible residues :
1) Use a cloth soaked with water.
2) Remove visible residues from the lift and its
accessories (sling, handset, strap) from top to
bottom.
Cleaning :
1) Use a damp cloth with warm water mixed with
a mild detergent.
2) Scrub the equipment from top to bottom,
removing all visible residues.
3) Rinse with clean water any remaining residual
detergent. Then wipe clean with a dry cloth.
Voyager’s Special Areas to Clean
Fig. 9
To ensure a better rolling surface for the trolley
wheels, clean the inside of the rail every
4 months. To do so, insert a damp cloth in the
opening and slide it from one end of the rail to the
other.
NOTE: It is recommended to clean the lift
and its accessories between each patient
use.
NOTE: Pay special attention to areas
pointed in. These are most likely to enclose
germs. Use a smaller brush and/or cotton
swab to reach them.
CAUTION: Do not drench the product, as
this could damage electrical components
and cause internal corrosion.
If a hot air dryer is used to dry the lift, the
temperature must not exceed 80°C (176 °F).
Do not use petroleum-based solvents, as
this may damage plastic parts.
Emergency stop/
battery eject button
Up/Down button
membrane
Hand control
edge
Hand control
back and handle