Figure 45
Auralis
Figure 46
START THE AURALIS SYSTEM
32
Start the Auralis system
Before using any of the Auralis mattress or Auralis
seat cushion systems make sure:
• The
Auralis
system is assembled correctly in
accordance with
VHFWLRQ³$VVHPEOHWKH$XUDOLV
V\VWHP´RQSDJH
•
7KH&35UDSLGGHÀDWLRQXQLWRQWKHPDWWUHVVLVLQ
closed position.
Auralis system start-up
(5 steps)
When the Auralis pump power cable is connected
to a power source, the Auralis pump sounds with
a start-up tone and a self-diagnostic check runs
for 10 seconds. Once the check is completed the
Auralis pump beeps twice and is ready for use.
1. Press the Run/Standby button on the control
panel for 2 seconds.
The following indicators are shown:
• Run/Standby
• Wait
indicator
• Alternating mode button
• Comfort control indicator
• Battery charge indicator
• Green indicators on the front of the pump
See Figure 45
7KH$XUDOLVPDWWUHVVLVIXOO\LQÀDWHGZKHQWKH:DLW
indicator is off, after approximately 15 minutes.
The Auralis Plus mattress takes approximately 17
PLQXWHVWRUHDFKIXOOLQÀDWLRQ
2. When the Auralis
PDWWUHVVLVIXOO\LQÀDWHGLIDEHG
VKHHWLV¿WWHGWXFNLWLQORRVHO\0DNHVXUHWKDWWKH
&35UDSLGGHÀDWLRQXQLWLVFOHDUO\YLVLEOHDWWKH
head end of the bed.
3. Place the patient on the Auralis
mattress with the
head at the head end and the feet at the foot end.
See Figure 46
Continue with steps on the next page.
NOTE
The Auralis
pump automatically adjusts the
pressure in the mattress to support the patient.
