2
2
4
5
PELLET STOKER KMP PX22
6G>I:GBHL:9:C67
Installation Instructions -
2010.06.22 - 9/16
NOTE!
All work as described in the following text must be done by a qualified
person.
Changing the ignition element
1. Remove the burner cover by removing the two nuts and screws that hold the
cover in place and then pull the cover backwards.
2. Remove the two screws at the side of the bottom and fold the bottom plate
down.
3. Disconnect the firing element’s cables from their terminals (2 x blue).
4. Remove the two screws on the bottom, under the stoker.
5. Remove the screw that holds the element and pull out the element from its pipe.
6 Replace the element.
7. Refit in reverse order.
8. Ensure that the firing element is slid forward towards the inner pipe.
Changing light sensor
1. Disconnect all three cables on the stoker.
2. Remove the burner cover by removing the two nuts and screws and pull the
cover back.
3. Disconnect the edge connector from the control circuit board and pull out
the sensor from its hole to the right of the fan.
4. Push the new sensor into the hole until it gets stuck. Be sure to align it
perpendicular to the surface. Connect the edge connector and reinstall the
burner cover.
NOTE!
When an ignition failure occurs, don’t open the hatch until the combustion
chamber is properly ventilated!
Fig. 6 Ignition element
