Ariterm px22, Installation And Use Manual

Page: 10 / 16

PELLET STOKER KMP PX22
6G>I:GBHL:9:C67
Installation Instructions - 2010.06.22 - 10/16
Troubleshooting and repair
Fault Cause What to do
The burner stops,
Fault code ErrSafe
The burner stops,
Fault code ErrStart
UÊÊ / iÊLÕÀ˜iÀÊ >ÃʜÛiÀ i>Ìi`°
UÊÊ / iÊLÕÀ˜iÀÊ >ÃʘœÌʏˆÌ°Ê
Clean the burner and boiler.
Reset the fall pipe’s overheat
protection.
Check the pellet supply and the
starter dose “Ign dose”.
The burner stops UÊ / iÊLÕÀ˜iÀÊ>˜`ɜÀÊLœˆiÀÊ
need(s) sweeping.
Clean the burner and boiler.
The burner stops,
Fault code ErrLow
UÊÊ / iÊLÕÀ˜iÀÊ >ÃÊ}œ˜iʜÕÌʈ˜Ê
low output mode.
Check the pellet supply and the
“Feed LO” and “Air LO” settings.
The burner stops,
Fault code ErrHigh
UÊÊ / iÊLÕÀ˜iÀÊ >ÃÊ}œ˜iʜÕÌʈ˜Ê
high output mode.
Check the pellet supply and the
“Feed HI” and “Air Su” settings.
The burner stops,
Fault code GOutStrt
UÊÊ / iÊLÕÀ˜iÀʏˆÌÊLÕÌÊÌ i˜ÊÜi˜ÌÊ
out during pre-operation.
Check the pellet supply and the
“Feed SU” and “Air Su” settings.
(ServCode)
The burner stops,
Fault code ErrorIgn UÊÊ / iÊwÀˆ˜}Êii“i˜ÌʈÃʘœÌÊ
drawing any power.
Check the connections to the firing
element (120 - 145 Ohm) or replace
the firing element.
The burner stops,
Fault code Tempsens
The burner stops from
time to time and with-
out any visible cause.
UÊÊ / iÊVœ˜ÌÀœÊVˆÀVՈÌÊLœ>À`Ê >ÃʘœÊ
contact with the temp. sensor.
UÊÊ >ÞÊLiÊ`ÕiÊ̜Ê̜œÊ>À}iʜÀÊ
strong variations in vacuum in
the chimney, or fuel feed fault.
The temperature sensor circuit
may be broken by the external
thermostat or switch. If not, check
the connections to the temp. sensor
or replace
Contact your authorised installer for
overhauling and any installation of
draft inhibitors.