2
CyberDome Programming Instructions
C
YBER
D
OME
S
ETUP AND
P
ROGRAMMING
This manual contains programming instructions for the CyberDome Day-Nite™, CyberDome
Select™, and standard CyberDome™ 16X high-speed surveillance domes.
The CyberDome offers several setup and programming options for operation and preset
functions. The controller keypads can be used to enter initial programing and setup for the
CyberDome cameras, as described in the following section. There are two basic models of
keypad: the ATD-304 provides joystick control while the ATD-300 uses arrow keys to control
direction and also provides VCR control. Refer to the keypad manuals for more information.
Once CyberDome programming has been accessed, turn to the appropriate section in this
manual for the specific programming.
S
ETTING
E
LECTRONIC
A
UTO
P
AN
L
IMITS FOR THE
D
OMES
To set the electronic auto pan limits on dome receivers, first position the dome at the limit.
While holding down the
zoom
in
and
zoom
out
keys, press the arrow keys or move the joystick in the
direction of the limit being set (depending on the Digiplex keypad used).
Example:
To set the left limit, move the dome to the position of the desired left limit. While
holding down the
zoom
in
and
zoom
out
keys, press the
key or move the joystick left.
A
CCESSING
S
ETUP AND
P
ROGRAMMING
M
ENUS
1.
Beginning at the normal operating menu display, proceed as follows:
Figure 1: Normal Operating Display
CAMERA 000
MONITOR 01
Press and hold the
set
key until the following menu display (Figure 2 or Figure 3,
depending on the keypad being used) appears:
Figure 2: Code Entry Display ATD-300
CAMERA 000 (CODE)
MONITOR 01 (---------)
Figure 3: Code Entry Display ATD-304
ENTER PROGRAMMING
CODE : _
2.
Enter the access code
9
,
5
,
1
,
seq
. The display will automatically advance to
the next menu. Again, the menus between the keypads will be slightly different.
