Aritech ADVISOR CD72, User Manual

Page: 10 / 24

Page 10
User Manual for CD72/95/15003
D
ISARMING A SYSTEM AFTER AN ALARM
The bell and the flashing light are activated when an alarm is triggered in the system. If your system
has the option, a report of the event is automatically sent over the phone lines to a central station. If
you inadvertently activate an alarm, immediately telephone the central station to prevent an
unnecessary response.
When you enter the premises after an alarm, the bell may already be silent if it has been so
programmed. This allows there to be several alarms. Remember to record the fault or alarm in your
logbook for future reference.
1. Go to the keypad. The entry period starts as soon as you
open the entrance door, or when you enter the entry
zone. You can switch off the system without activating the
alarm as long as the beeping continues.
The red ALARM LED is lit on the control panel.
Beep Beep
The current day, date and time are displayed. An example
is shown.
TUE 23 APR 07.39
2. Press the key 0 and then enter your code. A ‘*’
appears in the display for every key you press. Use the
0
key to cancel an incorrect entry and to restart a new entry
code.
Enter Code
0 + code
Enter Code ****
Disarm?
3. Press the
Accept
key.
! ! ! !
A list of triggered zones will be displayed.
Events in Log...
In this example, the alarm was triggered in zone 4 ‘Back
Door’ on 23 April at 5.20 am in area 1.
004 Alarm
004 Back Door
23 APR 05.20 A1
4. Press the Accept key to confirm the alarm.
!
! !
!
System Disarmed
TUE 23 APR 07.40
Step 3 above may be automated by the system. If so, you will not have to press the Accept key.
RECORD THE FAULT OR ALARM IN YOUR LOGBOOK !