Revised by R. Robinson
Issue AV1.13 8 June 2006
61
Zone 609
VSU TKR (CO = CO line number)
Default value =
00000000
THIS FUNCTION IS ONLY AVAILABLE FOR THE AV20//38
Range =
N/A
This zone allocates the Voice Channel number to be used by the CO lines.
0 = Incoming line to be answered by both Voice Channels 1 and 2 (Number 63 and Number 64)
1 = Incoming line to be answered by Voice Channel 1 only (Number 63)
2 = Incoming line to be answered by Voice Channel 2 only (Number 64)
Related Zones.
Zone 610
DID N
(SET = indial pair number)
Default value =
00
NOTE: AV256 = 255 DID sets.
AV38 = 80 DID sets
Range =
00~99
NOTE! IF 00 IS TO BE USED AS A DID (AV38 only), IT MUST BE IN SET 01.
This zone allocates the last two (AV38) or three (AV256) digits of the
CALLED NUMBER
to a Set (Line-
Station pair) for matching a called number to a station number to achieve the indial facility.
The system uses this zone as a “look up” table to determine which station should ring if the ISDN call was to a
particular telephone number. After determining (from this zone) which set the line is allocated to, the system
then looks at
to determine which station is allocated to the same set.
An entry of 00 or 000 indicates end of the list. Ie.: there are no more numbers to check (Except in set 01).
NOTE!
can be used to cancel DID for day, night or both.
Related Zones.
,
,
for Call Forwarding with DID.
Zone 611
DID S
(SET = indial pair number)
Default value =
00
Range =
station numbers available
This zone allocates the Station number to be paired to an indial CO line.
A station is allocated to a “set” in
. This means that only the station here will ring on a call to an
assigned incoming number. All DID numbers must be assigned in
has 00 or 000 as the station
number, it will revert to
ringing assignment.
Related Zones.
,
,
Zone 612
ISDN Term
(CO = CO line number)
Default value =
1111111111111111
Range =
N/A
This zone controls the termination resistor. The system requires that the ISDN equipment be terminated by the
terminating resistors.
0 = Unterminated ISDN Line
1 = Terminated ISDN Line
The default condition is terminated.
Related Zones.
None
Zone 613
ISDN Type (CO = CO line number)
Default value =
1111111111111111
Range =
0~2
This zone allocates the ISDN type of line connected to the system.
NOTE!
Telstra Call Diversion is not available on
Point to Multipoint connections
FOR POINT TO MULTIPOINT CONNECTIONS (AV256 & AV38)
0 = Telstra Microlink
1 = Telstra OnRamp (Default) CORRECT CONNECTION
2 = Taiwanese ISDN
FOR POINT TO POINT CONNECTIONS (AV38 ONLY)
4 = Telstra Microlink
5 = Telstra OnRamp (Default) CORRECT CONNECTION
6 = Taiwanese ISDN
Related Zones.
