36
Tensor
2
7.
Additional options
7.1
Internal manual override (mechanical)
Operating the manual override with a power tool is not permitted, the
transmission can be destroyed due to the high speed!
Turn the drive shaft with a fl at-tip screwdriver at the manual override until the desired position is reached.
7.2
Option hand wheel
Danger of mechanical stroke.
The hand wheel is only allowed to be used if the system power is turned off!
1. Turn off operating voltage of the actuator.
2. Press down hand wheel and turn to desired direction. Adjusted positions remain.
3. If the desired position is reached release the hand wheel (the coupled state releases).
The hand wheel does not rotate in decoupled state.
8.
Parameter RESET
The parameter reset function is implemented in order to restore the factory settings.
Perform the Parameter-RESET:
•
In de-energized state switch into HAND mode
•
Hold buttons L&R down
•
Turn on power supply and still hold down buttons
•
While pressing the buttons L & R, the LED near the buttons blinks as follows:
1. LED blinks slowly
2. LED blinks fast
3. LED lights permanently
•
Release buttons L & R. The "Error Code 51" is displayed. Afterwards, the end positions of the actuator have to be set new.
Furthermore, all settings should be checked and adjusted, if necessary.
CAUTION
CAUTION
