6209020 07/2013 - Rev.02
46
Arimar Spa boats are manufactured with first quality materials. To keep
them in good conditions, at the end of the season clean and wipe the boat,
then store it in dry places, away from heat sources and with tubes inflated
with a few litres of air. When required, wash the boat with water and
neutral shampoo. At the end of the season, or when required, the wooden
parts of the boat must be checked and repainted with “marine” paints.
Every 6 months, check the boat outlets, plugs and gaskets. Replace if
necessary. Periodically activate the boat floodgates to avoid blocking.
Should the inflatable parts need to be serviced, contact your dealer or one
of our technicians. They will provide you the necessary information to carry
out the repair by yourself, by using the special user-friendly bicomponent
adhesive, as well as advising you should any other procedure be needed.
NOTE
The inflatable boats should not remain at anchor for long periods of time. To
extend the boat life it is advisable to run the boat aground and check the hull.
WARNING
All details on all Arimar boats (handles, supports, screws, etc.) are made of
stainless steel material, therefore it is advisable, after protract use in salty
water, to wash it with not salty water, to keep its original look. In case
anomalous colours would appear (similar to rust), this is due exclusively to
atmospheric and marine pollution. Therefore it is enough to clean with
special products for stainless steel.
WARNING
In the tubular, to avoid vulcanization and the councils of the presumed expert.
Only contact skilled technicians. They will solve your problem with no damage.
WARNING
To clean the tubes DO NOT ever use high pressure water jet machines, especially
with hot water. The water jet machine can be used to clean fibreglass
components, paying attention to keep the water jet at least at 10/15 cm from the
fabric.
