- 26 -
EN
INsTRUCTIONs FOR UsE
-
PLACE THE CHARGING STATION (I)
on
a hard surface and against a wall with no
obstacles within one metre on each side
and for about two metres to the front.
Plug the power cord (F) into the socket (M)
in the charging station and then connect the
battery charger to the main power.
The power light (L) in the charging station
will switch on to show that it is correctly
connected.
-
TURN THE SWITCH (Q)
on the base of the appliance to ON, to charge up the appliance for operation.
If the appliance has switched on correctly, the icons (2-3-5-6) will start to flash.
Important!
If the Robot is connected to the mains power without first switching it on at the ON but-
ton, the display will show the “E10” error code, the icons 2-3-5-6 will start to flash and
an intermittent acoustic signal will be sounded to warn that no charging has taken place.
-
CHARGE THE BATTERY:
the Robot is powered by a rechargeable Ni-Mh battery.
The charge modes are:
a) Directly via adaptor (F)
Plug the charger (F) directly into the socket
(Y) in the appliance body (Q).
Important!
Never use this charging methods when the Robot has been set to switch on later for cle-
aning (see the “Programming” chapter), as this could cause damage to the power cord
and to the appliance at the start of the cleaning cycle.
1 m
1 m
2 m
