ARIETE 2712/1, Manual

Page: 38 / 90

- 36 -
EN
VIRTUAL WALL
the virtual wall serves to prevent the Robot from accessing areas where access is not allowed. For
best results, position the virtual wall outside the inhibited area entry.
the virtual wall may have a radius of action up to 3 mt.
- Install the batteries into the apposite
housing (type D or R20) first, after hav-
ing raised the lower lid (3), as shown in
the picture. to close the lid, after having
inserted a side into the opening, mount
the other end by pressing it.
Important!
If the appliance is not used for a prolonged period of time, remove the batteries.
- Position the virtual wall into the working
position and turn the switch on (2). Direct
the caption “ ” on the virtual wall
towards the area in which the signal will
have to be sent.
- turn the switch (2) off in case the virtual
wall is not used.
DURING THE CLEANING CYCLE
the coverage time for a room may vary according to floor type and to the number of obstructions the
Robot encounters as well as the possible differences in height on the floor.
thanks to its front anti-collision sensors, the Robot is able to intercept surfaces (walls, furniture…)
avoiding collisions with them. However, if the obstruction consists of corners or tubular parts of furnish-
ings, then a gentle impact may be possible. Special anti-fall sensors on its base mean that the Robot is
able to recognise differences in height and therefore, to avoid falling from tops or stairs.
the Robot is also able to overcome differences in level such as thresholds or rugs and to move away
from obstacles (pipes, floor lamps, etc.) of no higher than 1 cm.
Important!
When cleaning carpets or rugs, do not allow the Robot to come into contact with frin-
ges and do not clean shag pile carpets, as the fibres and fringes may become caught up
around the rotary brushes.