ARIETE 2712/1, Manual

Page: 32 / 90

- 30 -
EN
INSTRUCTIONS FOR USE
- PLACE THE CHARGING STATION (N)
on a hard surface and against a wall with
no obstacles within one metre on each
side and for about two metres to the front.
Plug the power cord (I) into the socket (P)
in the charging station and then connect
the battery charger to the main power.
the power light (o) in the charging station
will switch on to show that it is correctly
connected.
- TURN THE SWITCH (T) on the base of the appliance to oN, to charge up the appliance for opera-
tion. If the appliance has switched on correctly, the icons (13-14-16-17) will start to flash.
Important!
If the Robot is connected to the mains power without first switching it on at the ON
button, the display will show the “E10” error code, the icons 13-14-16-17 will start to
flash and an intermittent acoustic signal will be sounded to warn that no charging has
taken place.
- CHARGE THE bATTERY:
the Robot is powered by a rechargeable lithium battery.
the charge modes are:
a) Directly via adaptor (I)
Plug the charger (I) directly into the socket
(Y) in the appliance body (P).
Important!
Never use this charging methods when the Robot has been set to switch on later for
cleaning (see the “Programming” chapter), as this could cause damage to the power
cord and to the appliance at the start of the cleaning cycle.
1 m
1 m
2 m