Step Four: Install Discharge
Chute Rod Cont.
7.
Hook the chute control cable onto the chute rod.
IMPORTANT:
The chute control cable hook will prevent the cable
from contacting the engine or muffler guard. Make sure the cable
stays connected while unit is in operation.
8.
Check to make sure the chute control cable ends are properly
seated in control assembly and control arm.
9.
Replace gear cover on top of chute pedestal.
10. Orient the chute and pedestal to its most vertical position and
tighten pedestal hardware to 15-31 lbf-ft (20-42
N∙m).
11. Make sure the discharge chute rotates left and right when you
push the discharge chute control lever left and right.
NOTE:
If chute does not stay in position, adjust as directed in
Discharge Chute Contro
l in Owners Manual.
Summary of Contents for Sno-Thro Pro 32
Page 17: ...Step Thirteen Starting the Engine...
Page 19: ...Starting Engine Step B Fuel Valve Turn the fuel shut off valve to the ON position...
Page 22: ...Starting Engine Electric Start Step E Key Turn key to start position...
Page 23: ...Starting Engine Manual Start Step E Key Turn key located on dash to run position...
