GB - 24
ATTACHMENT DRIVE BELT
REPLACEMENT
Remove Attachment Drive Belt
(Figures 25, 26 and 27)
1. Move power and PTO switches to the
OFF position. Remove key.
2. Disconnect batteries.
3. Loosen the hardware securing belt
cover to unit.
NOTE:
DO NOT completely remove the
hardware from unit.
4. Remove the belt cover.
5. Remove spring pin from chute crank and
separate.
6. Remove remote deflector control cable
from dash control.
7. Remove belt fingers by removing hex
bolts mounting belt fingers to frame. See
8. Remove attachment drive belt from drive
pulley.
IMPORTANT:
To avoid bending bottom cover,
when tipping unit apart, support handlebars
firmly or tip unit up on housing and remove
bottom cover by removing six cap screws
before separating unit.
9. Support Sno-Thro frame and housing.
10. Remove hex bolts securing housing to
frame (two on each side). Tip housing
and frame apart on pivot pin. See
11. Remove attachment drive belt from
attachment pulley (hold brake away from
belt).
Figure 24
1. Shift Rod
2. Adjustment Pivot Pin
3. Speed Selector Arm
4. Hairpin
OS8060
CAUTION:
Always support Sno-Thro
frame and housing when loosening
the cap screws holding them
together. Never loosen cap screws
while unit is in service position.
WARNING:
Before tipping unit up
onto housing, both batteries must be
removed from the unit. Ensure unit is
secure and will not tip over during
maintenance.
Figure 25
1. Belt Fingers
2. Attachment Drive Belt
OS2625
Summary of Contents for 916302 amp 24 sno-thro
Page 37: ......
