Ariens 916302 amp 24 sno-thro, Owner'S Manual

Page: 31 / 38

GB - 31
Unit throws snow
poorly or does not
throw snow. 1. Shear bolts broken. 1. Replace shear bolts
(see Shear
Bolts
on page 22).
2. Attachment clutch/brake
not adjusted properly.
2. Adjust attachment clutch/brake
(see Attachment Clutch/Brake
Adjustment
on page 26).
3. Auger is frozen in place. 3. Move unit to a warm place to
thaw.
4. Ice or debris is obstructing
auger.
4. Move PTO and key switches to
OFF position. Remove key from
switch. Clear blockage from
auger or chute
(see Snow Clean-
Out Tool
on page 15).
5. Attachment drive belt
slipping, worn or damaged.
5. Adjust or replace attachment
drive belt
(see Attachment
Clutch/Brake Adjustment
on
page 26).
Controller displays
flashing red light
under the cover. 1. A trouble code has been
set in the electrical system:
____ = long flash
• = short flash
Code:
Perform the suggested correction. If
trouble code resumes contact your
Ariens Dealer.
1. ____ •____•
(Motor Coil Overheated)
1. Turn key to OFF position, allow
unit to fully cool before resuming.
2. ____ • •____• •
(Motor Position Error)
2. Contact your Ariens Dealer.
3. ____ • • •____• • •
(Controller Overheated)
3. Turn key to OFF position, allow
unit to fully cool before resuming.
4. ____ • • • •____• • • •
(Low System Voltage)
4. Charge batteries
(see Low
Battery Voltage
on page 18).
5. ____ ____• •____ ____• •
(Stall Mode)
5. Move PTO and key switches to
OFF position. Remove key from
switch. Clear blockage from
auger or chute
(see Snow Clean-
Out Tool
on page 15).
NOTE: Unit must be OFF for a
minimum of 30 seconds before
resuming.
TROUBLESHOOTING
PROBLEM PROBABLE CAUSE CORRECTION
Controller