Avon Protection
4 DAS775571AA Version 9, December 2015
GR 13313 CR121804
1
SAFETY AND REGULATORY INFORMATION
Before using this product, the customer shall read and understand all the instructions and warnings. Avon
Protection does not accept responsibility for damage or injury resulting from failure to follow the
instructions provided.
Refer to Product Safety datasheet PSD776352A for safety and warning notes
1.1
FCC COMPLIANCE INFORMATION (US)
When using the argus
®
Mi-TIC camera or charging the argus
®
Mi-TIC camera and battery in the
Charger (charge mode), these modes have been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a residential environment. This equipment
generates, uses and can radiate radio frequency energy and, if not installed and used in accordance
with the instruction manual, may cause harmful interference to radio communications.
When downloading data from the argus
®
Mi-TIC camera / Charger (data download mode), this mode
has been tested and found to comply with the limits for a Class A digital device, pursuant to part 15
of the FCC Rules. These limits are designed to provide reasonable protection against harmful
interference in a commercial environment. This equipment generates, uses, and can radiate radio
frequency energy and, if not installed and used in accordance with the instruction manual, may cause
harmful interference to radio communications. Operation of this equipment in a residential area is
likely to cause harmful interference in which case the user will be required to correct the interference
at their own expense.
Any modification not approved by Avon Protection could void the user’s authority to operate this
equipment.
1.2
TUV Label
1.3
NFPA 1801
The following camera models
•
MI-320-1-NFPA
•
MI-320-1-E
•
MI-329-1-NFPA
•
MI-329-1-E
•
MI-320-3-NFPA
•
MI-320-3-E
•
MI-329-3-NFPA
•
MI-329-3-E
comply with the requirements of NFPA 1801 standard on Thermal Imagers for the Fire Service 2013
edition and bear the appropriate labelling.
To maintain NFPA 1801 / ANSI 12.12.01 compliance, cameras must be used with ARG_MI_BLPSN,
ARG_MI_BLPYN or ARG_MI_BLPXN batteries.
See the product label
for EU and other
regulatory information
