Argon 18 ELECTRON PRO, Assembly Manual, Page: 18 / 33

18
ELECTRON PRO: 9.1. Steerer Module Setup Instructions
Cut line
Mark
± 3mm
2. The design of the steerer module allows it to be cut to length based on
stem height position, similar to a standard fork steerer. You will need to cut the
aluminum steerer as shown (use standard steerer cutting jig).
3. File down and cut end of steerer clean to make sure it is free of burr.
4. Insert stem, align with wheel and compress down using top cap and 8mm Hex
Key.
5. Tighten stem according to manufacturer’s instructions.
6. Install preferred drop bar onto stem as per manufacturer’s instructions.