Argon 18 ELECTRON PRO, Assembly Manual, Page: 17 / 33

17
ELECTRON PRO: 9.1. Steerer Module Setup Instructions
1. Assemble steerer module using bolts
provided (2x front M6x12 + 1x central
M6x35). Make sure washer is placed
under central bolt. Tighten all bolts at
10Nm. Use an extended M5 Hex bit or
extension to access central bolt.
Note: you might want to temporarily
set up the steerer module in order
to fit rider, determine stem height
position, and cut line prior to
tightening bolts (see instructions
on following page)
.
Steerer Module
(80648)