The drain hose must be arranged beneath the copper pipe.
The drain hose must not be hunched or bended.
Do not wrap the drain hose by pulling it.
When the drain hose must be through the house, it should be
wrapped by the special heat insulated materials.
The copper pipe and the drain hose must be wrapped by felt
strip. Heat insulated pad should be used in the place that the
pipe contact the wall.
NOTE:
1
1
2
2
3
3
INSTALLATION
ROUTE OF PIPE
If pipe came out of the right side of the indoor unit, cut part
1
on the unit;
If pipe came out of the lower-right side of the indoor unit, cut p-
art "2" on the unit;
If pipe came out of the left side of the indoor unit, cut part
3
on the unit.
drain hose
gas pipe
liquid pipe
felt
adiabatic
underlay
REFIT OF DRAIN HOSE
If pipe comes out of the left side of the indoor unit,the drain hose
must be refit, otherwise water leakage may occur.
Refit methods: Interchange the position of drain hose and drain
rubber bib, the right diagram is un-refit position.
Clearance is not allowed after refit, it would lead to water leak.
Arrangement of drain hose
To eject the condensate water easily, the drain hose should be declined downward.
The arrangement in diagram2-5 is wrong.
If the drain hose connected with the indoor unit is short, it may
be extended by the hose in the accessory box.
When the drain hose must be through the house, it should be
wrapped by the special heat insulated materials.
decline
decline
downward
downward
(Fig. 1)
(Fig. 2)
(Fig. 3)
(Fig. 4)
water
leak
standing
water
air
water
leak
dip hose in water
drain hose
hose(ID 15cm)
PVC hard
(Fig. 5)
50mm or less
from floor
1
4
4
Installation drain hose
1
5
5
Installation indoor unit
1
6
6
Drain cap
Drain cap
Drain
Drain
1
1
2
2
3
3
Insert the piping through a hole in the wall, and
hook the Indoor unit onto the upper position of
installation plate (engage the two hooks of the
rear top of the indoor unit with the upper edge
of the installation plate)
After setting the clamping cover of piping in the
hooks in the direction shown by the arrows and
in the order shown by and to fix it temporarily,
then tighten the piping cover fixing screw to fix
it securely.
Tapping
Piping
Drain hose
Clamping cover of piping
Piping cover
fixing cover