Argo ACS100PH, Technical Data & Service Manual

Page: 133 / 134

5
5 - 9
●
Settings mode 2
<Operating procedure>
(1) Press and hold the button, button, and button simultane-
ously for 4 seconds or longer.
(2) Use the temperature setting and buttons to change the item
code. The item codes and setting data are shown in the table below.
(3) Use the timer time and buttons to change the setting data.
To confirm the changed setting data, press the button.
(At this time, “Setting” stops blinking and remains lit.)
(4) During this mode, “Setting” is displayed, blinking. The display shows the
set outdoor unit address “System XX-YY” (System XX = System
address, YY = Address at outdoor unit sub-bus), item code number (DN
value in the table below), and the setting data (6 digits).
(The setting data is displayed in 6 digits. The display changes between the first 3 digits (Fig. ) and the last 3
digits (Fig. ). When the first 3 digits are displayed, the top point of the colon is lit.)
(5) To end the setting mode, press the button. The display returns to the normal display mode.
B
A
80: <Refrigerant type> A and B are displayed alternately. (Example shows 000 410 (R410A).)
Display of first 3 digits Display of last 3 digits
A B
(5)
(1) (3)
(2)
(5)
(1) (3)
(2)
04-309 Sanyo-5 10/27/04 1:51 PM Page 9