Audio Resource Group, Inc. • 405 Main Ave W, Unit 4G • West Fargo, ND 58078 • ©2016 Audio Resource Group, Inc. • All Rights Reserved
www.argaudio.com
Page 2
CONTROL FUNCTIONS:
The buttons on the receiver perform the functions as detailed below:
1. Channel Up Button
6. Set Button
12. Screw 2 (Used to change the
headphone jack)
2. Channel Down Button
7. Delete Button
13. C-SAFE Port (Vin Power in)
3. Volume Up Button
9. Memo Button
14. Replaceable headphone jack
module
4. Volume Down Button
10. Mute Button
15. Auto Power ON/OFF and
3.5mm Stereo Audio Jack.
5. Mode Button
11. Screw 1 (Used to change the
headphone jack)
MOUNTING INSTRUCTIONS:
The ARG 900MHz receiver is a universal unit designed to be compatible with most makes and models of cardio
equipment. To mount the Receiver:
1. Determine the appropriate location to mount the receiver to the cardio equipment. Take note the range of motion of
the components of machine and make sure the placement of the receiver and its cabling will not interfere with
operation of the machine or any safety features.
2. Slide the cable ties through the appropriate holes in the mounting cleat on the underside of the receiver. (Top to
bottom if you are mounting it to a horizontal bar or side to side if you are mounting to a vertical bar.)
3. Wrap and thread the cable ties around the bar on the cardio machine at the predetermined location. Pull the ties
tightly around the bar so the receiver does not move or rotate. Be careful not to over-tighten the ties to avoid cracking
the mounting cleat or case of the receiver. Trim off the excess ends of the cable ties.
4. Connect the power cable to the receiver. The receiver can be powered by either a CSAFE power outlet on the
cardio machine or an A/C power converter that can be plugged into the wall/floor. (Power adapters and cables are not
included and must be ordered separately.) If you are using a C-SAFE connection: connect one end of the Cat-5 cable
to the C-SAFE port on the cardio machine. (Check with the equipment manufacturer to make sure the machine has
this feature and for location of the outlet.) The other end of the cable connects to the RJ45 receptacle on the back of
the receiver. If you are using an A/C power supply: locate a standard 110V outlet and plug the 12V A/C adapter side
into the outlet and the RJ45 plug into the receptacle on the back of the receiver. Make sure to route the cord for either
option appropriately to avoid interference with any of the functions or safety features of the cardio machine.
Note: Once mounted, the receiver can be rotated by lifting the main unit away from the cardio equipment and
rotating it to the desired angle. It will lock back down on its own. Verify that the unit is locked correctly by
gently turning the unit to the right or left.
