Audio Resource Group, Inc. • 405 Main Ave W, Unit 4G • West Fargo, ND 58078 • ©2016 Audio Resource Group, Inc. • All Rights Reserved
www.argaudio.com
Page 5
SETTING COPY:
New ARG receivers have the ability to copy settings from one unit over to another unit. This
greatly speeds up programming multiple units as it takes approximately one minute to copy all settings. To copy from
one unit to another an optional programming module is required. (ARG-PM03).
1. Program one receiver manually. This receiver will be referred to as the master receiver. The other
receivers will be referred to as slave receivers.
2. Plug the programming module into power and connect two C-SAFE cables to the programming module.
3. Remove the headphone module from the master receiver by removing the two set screws in the front of the
unit.
4. Connect the other end of one of the C-SAFE cables from step 2 to the master receiver and the second C-
SAFE cable to the slave receiver.
5. On the master receiver locate the small button in the headphone jack compartment.
6. Press this button once. ARG Audio recommends using a paperclip for this.
7. At this point the backlight on both the master and slave receiver will turn on. This means that the
programming has started.
Do not disconnect either receiver from the programming assembly until
copying has completed as this could cause damage to the receivers.
8. Programming will take approximately one minute. After programming has ended both backlights will turn off.
9. Disconnect both receivers and test the slave receiver to see if programming has copied.
10. Repeat steps 4 through 9 for each additional receiver to be programmed.
11. After programming all receivers has been completed, replace the headphone module and insert and tighten
the two set screws.
