9
Install 4 of the rubber bands to secure the
wing as shown in the photo above.
Slip collet adapter onto motor shaft followed
by spinner backplate,propeller and prop nut.
Tighten nut and install spinner nose piece.
The photo above shows the correct order
of installation for the propeller. Install collet
back plate on collet adapter.
Completed installation should look like
photo above.
NOTE:
DO NOT install prop until after
initial aircraft setup and testing.
INSTALLING FLIGHT BATTERY
The included 1000mAh 3-cell 11.1V LiPo battery
is a perfect fit for the battery box located on the
bottom of the fuselage. The flight battery installs
with the base of the battery facing forward.
Plug the balance connector wires into the LED
Y-connector to light the LEDs. Plug the female
HCT connector from the flight battery into the
male HCT connector from the ESC. Once
correctly plugged in, the wires can be tucked into
the battery box and the battery hatch door can be
re-installed and snapped into place. The servos
are active at this point and the motor is armed.
