7
AIRPLANE ASSEMBLY
Assemble the vertical tail to the horizontal
tail.
Place the tail assembly into position on the
fuselage.
Insert the two 5/16” (8mm) long screws
from the tail screw bag into the holes on
fuselage bottom and tighten.
Connect the plastic clevis to the rudder
control horn in the outermost hole and
snap closed. Repeat for elevator clevis.
Photo shows clevis connected to the eleva-
tor control horn in the outermost hole. The
clevis keeper is in correct position.
Install the tail wheel bracket with two small
screws.
Slip plastic clevis keeper onto clevis. This
is to prohibit the clevis from popping open
during flight.
Photo shows clevis connected to the rud-
der control horn in the outermost hole. The
clevis keeper is in correct position.
