QUICK-START GUIDE
Full manual available to download from: www.Ares-RC.com
1
Remove the components from
the box and ensure you have the
following parts:
Fuselage assembly, a left- and
right-hand wing panel, stabilizer, fin
and rudder, charger, mains power
adaptor, LiPo battery, propeller,
spinner, prop driver, wheels and
undercarriage legs, main spar,
wing fixing plate and retainer, glue
and tool set plus KA-6 transmitter.
This Quick Start guide is written for the RTF (Ready to Fly) version of the Crusader II.
If you have the PTF (Pair to Fly) version, your model comes complete with a pre-installed
Hitec Red-enabled receiver. Simply pair (connect) with your existing 2.4GHz Hitec or Hitec
Red-enabled transmitter using the pairing guide on last page of this Quick Start guide.
A full instruction manual is available to download from www.ares-rc.com
2
Apply a generous but even spread
of glue (in the area indicated by the
cross hatched lines) to the top and
bottom surface of the horizontal
stabilizer.
3
Slide the horizontal stabilizer into
its slot at the rear of the fuselage
and push it fully home.
4
Apply a generous but even spread
of glue on either side of the
vertical stabilizer (as indicated by
the cross hatched lines).
