Arecont Vision MegaDome
®
2 Installation Manual
Page | 21 [email protected]
Heater Kit MD2-HK Installation Instructions
(Accessory Sold Separately, except
–H Models)
Note: Heater kit MD2-HK is not available on
MegaDome® 2 WDR models!
Inside the box:
A. Heater
B. Two (2) plastic stand-offs
C. Two (2) screws
Not included but needed:
D. #1 Phillips head screwdriver
Image 37
1.
Remove the heater kit from the box.
2. Connect the heater cable to the connector
on PCB as shown in Image 39. Red is
positive (+) cable.
NOTE 1: MegaDome® 2 Heater, MD2-HK, uses
2.28 watts which is different from the
MegaDome® Heater. (MD-1HK is 10 watts)
NOTE 2: Unlike the MegaDome® Heater (MD-
1HK), MegaDome® 2 Heater (MD2-
HK) doesn’t
need external power input.
3. With the heater element facing away
from the main board in the camera,
align the two (2) holes on the heater
board with the two holes on gimbal
base shown in Image 38.
4. Attach the heater board with the
standoff on gimbal base as shown in
Image 39.
Image 38
Image 39
C
A
Heater
Connector
Heater
B
