Arecont Vision MegaDome
®
2 Installation Manual
Page | 19 [email protected]
Pole Mount Adapter (MD-PMA) Installation Instructions
(Sold Separately)
Inside the box:
A. Pole Mount Adapter
B. 2x Compression Fittings
C. 2x Small Steel Straps
D. 2x Large Steel Straps
E. Pack of four (4) machine screws (#8-32
5/8
”)
Not included but needed:
SV-EBA (Electrical box adapter)
Image 31
1. Remove the pole mount adapter,
compression fittings, steel straps and
hardware from the box.
2.
Install the compression fittings to pole
mount adapter as shown in Image 32.
3.
Attach MegaDome® wall mount MD-WMT2
to pole mount adapter as shown in Image
33.
4. Run the Ethernet cable and outside power
cable (if necessary) through the
compression fittings and MegaDome®
wall mount, MD-WMT2.
5. Use the supplied two steel straps to attach
the Pole Mount Adapter to the pole and
tighten the compression screws as shown
in Image 33.
6. Attach the dome to wall mount adapter.
Please reference “Mounting the Camera,” if
needed.
7. Tighten the compression fittings to seal the
wiring holes.
Image 32
Image 33
A
B
C
D
E
MD-WMT2
Compression
Screws
