Ardo F010N, Manual, Page: 143 / 164

15
461306971 (RS-000)
L
C
P
M
5
GB
3. USER INSTRUCTIONS
CLEANING AND MAINTENANCE
• Prior to any maintenance work or cleaning,
disconnect the appliance from the electricity
mains.
• Do not use a steam cleaner to clean this
appliance.
• Do not wash the parts if they are still hot
• Never use abrasive powders, pads or corrosive
spray products.
• Do not leave vinegar, coffee, milk, salty water
or the juice of lemon or tomato on the surface
for any length of time.
EXTERIOR PARTS
All the parts of the oven exterior (stainless steel, side
panels, door glass) must be cleaned frequently with a
mild detergent and a little water and then dried with a
soft cloth.
Do not use rough or abrasive materials or sharp metal
scrapers to clean the oven glass doors as they could
scratch and cause the glass to break.
On painted or stainless steel surfaces,
do not use
aromatic or aliphatic solvents to remove spots or label
adhesive.
INTERIOR PARTS
We recommend cleaning the oven after every use
to remove all residues of food, grease and sugar,
which may burn with subsequent use, causing
permanent stains and unpleasant smells.
Always
clean the oven when slightly warm with soapy water.
Rinse and dry all surfaces thoroughly. Always wash all
accessories used.
Do not spray or wash the electric heating
elements nor the thermostat with acid-based
detergents (check the information label on the
product you are using). The manufacturer cannot
be held responsible for any damages caused by
incorrect cleaning.
OVEN SEAL
The condition of the oven seal is vital for the correct
functioning and performance of the oven.
We recommend you:
• Clean it, avoiding abrasive tools or products.
• Check its condition occasionally.
In case the seal has stiffened or presents
damages, contact your nearest Service centre
and avoid using the oven until it has been
repaired.
CHANGING THE OVEN LAMP (fi g. 5)
Attention!! Ensure the appliance is switched off
before replacing the lamp to avoid the risk of
electric shock.
If the oven lamp (L) has to be changed the new lamp
must have the characteristics indicated on page 16
and resistant to high temperatures (300°C). Turn glass
protection cap (C) counterclockwise and change the
lamp. Put the cap back on taking care to insert the
notches in the locking tangs and turn clockwise.