ARDISAM
13
❒
❒
❒
❒
❒
Attach Shift Lever Rod
1. Pass the lower end of the shift lever rod through the grommet in
the upper crossbar of the handlebar as shown.
NOTE: Shift handle should point downward.
2. Pass the lower end of the shift lever rod
through pivot on the left side of
the rod crank as shown.
3. Slide pin through hole
in shift lever rod.
❒
❒
❒
❒
❒
Fill Engine Crankcase
1. Add and change oil according to chart below.
Do not overfill.
Use
a high quality detergent oil classified "For Service SC, SD, SE,
SF, SG," such as Briggs & Stratton "Warranty Certified" SAE 30
oil, part no. 100005. Use no special additives with recommended
oils. Do not mix oil with gasoline.
Adapted from Briggs & Stratton Corporation, form No. 272646-10/93
*
Air cooled engines run hotter than automotive engines. Use of multi-
viscosity oils (10W-30, etc.) above 40
o
F (4
o
C) will result in high oil
consumption and possible engine damage. Check oil level more frequently
if using these types of oils.
**
SAE 30 oil, if used below 40
o
F (4
o
C), will result in hard starting and
possible engine bore damage due to inadequate lubrication.
IMPORTANT
Engine is shipped from factory without oil.
You
must add engine oil before starting engine.
UNPACKING AND ASSEMBLY
