Arctic Spas Arctic Fox, Owner'S Manual, Page: 62 / 124

Startup Programming
Water Temperature Regulation
In a regulation cycle, the system first generates water flow
through the heater housing and the plumbing, in order to
ensure accurate water temperature readings as well as
avoiding heater activation in dry conditions.
After verifying pump activation and taking a water temper-
ature reading if required, the system automatically turns
the heater on to reach and maintain water temperature at
Set Point.
The “Heater” indicator lights up when the heater is
on. It flashes when there is a request for more heat
but the heater has not yet started.
Cooldown
While performing this task, the heater is not allowed to
turn on and its icon flashes.
Smart Winter Mode
Our Smart Winter Mode protects your system from the
cold by turning pumps on several times a day to prevent
water from freezing in pipes.
The “Smart Winter Mode” indicator lights up when
the Smart Winter Mode is on.
Light Key
Press Light Key to turn lights on. A second press turns lights off. A
built-in timer automatically turns light off after 2 hours, unless it has
been manually deactivated first.
The “Light” indicator lights up when light is on
Up / Down Keys
Use Up or Down key to set desired water temperature. The tem-
perature setting will be displayed for 2 seconds to confirm your
new selection.
2 pump spas have a combined Up/Down Key. Hold the button to
increase the parameter and release the button to stop. Hold the
button again to decrease the parameter.
The “Set Point” icon indicates that the display shows the
desired temperature, NOT the current water temperature!
Program Menu
Press Light Key to turn lights on. A second press turns lights off.
The program menu is accessible by holding down the Light key for
5 seconds. In the program menu the following parameters can be
set: clock, filter or purge cycles, economy mode and temperature
units. While in the program menu, use the Up or Down key to
adjust the parameters and use the Light key to jump to the next
parameter. The changes will be saved after the confirmation of the
last parameter only. If there is no action taken for 10 seconds, the
system will exit the program menu without saving any changes.
Owners Manual - Core Series
62 62