Arctic Cove MODF001, Operator'S Manual

Page: 9 / 32

5 — English
UNPACKING
This product requires assembly:

Carefully remove the product and any accessories from
the box. All items listed in the Includes section must be
included at the time of purchase.
WARNING:
Items in this Assembly section are not assembled to
the product by the manufacturer and require customer
installation. Use of a product that may have been
improperly assembled could result in serious personal
injury.

If any parts are damaged or missing, please call
1-877-297-8911 for assistance.
WARNING:
If any parts are damaged or missing do not operate this
product until the parts are replaced. Use of this product
with damaged or missing parts could result in serious
personal injury.
WARNING:
Do not attempt to modify this product or create
accessories or attachments not recommended for use
with this product. Any such alteration or modification is
misuse and could result in a hazardous condition leading
to possible serious personal injury.
TOOLS NEEDED
Small phillips head screw driver, small wrench
ASSEMBLING THE STAND AND MOTOR HEAD
See Figures 4 - 7.

Turn the base lock counterclockwise to remove the base
lock and washer from the lower stand assembly.

Turn the base upside down.

Place the weight and washer (dome side down) inside
the base as shown in figure 5.

Insert base lock through the washer, weight, and base
then hold base lock in place and place the lower pole into
the base.

Secure pole to the base by turning the base lock
clockwise (see figure 6).
ASSEMBLY
ASSEMBLING THE MOTOR HEAD, FAN, AND
FAN COVERS
See Figures 8 - 13.
 Remove lock knob on top end of the stand assembly, set
aside.

Align the hole in the top of the upper pole with the hole in
the motor head. Install lock knob into holes and tighten
securely (see figure 7).
 Unscrew and set aside the four screws and the nose
guard from the motor head (see figure 8).

Attach the rear fan cover on the motor head.
NOTE:
The screw hole in the rear fan cover must
be at the bottom with Arctic Cove logo at the top.
(see figure 9).

Reinstall the four screws and tighten securely.

Place the fan blade on the spindle of the motor head and
align the pin in the spindle with the slot in the fan blade.
Use the nose guard to secure the fan in place as shown
in figure 10.

Remove the small screw and nut from the bottom of the
front fan cover. Carefully set aside.

Lift the lock levers and slide the hook at the top of the
front fan cover over the rear fan cover. Line up screw
holes at bottom of fan covers.
NOTE: The prongs on the hook must slide over the top
wire on the rear fan cover as shown in figure 11.

Push all the lock levers down to lock the front and rear
fan covers together.

Reinstall the screw and hex nut as shown in figure 12.
Tighten securely.
ATTACHING THE MISTING RING TO THE FAN
COVER
See Figures 13 - 15.

Loosen height adjusting knob and adjust stand to desired
height. Tighten securely.

Align the clips onto the wires of the front fan cover
pressing the clips in the positions as shown in figure 13.

With the misting tube facing down, push the misting ring
onto the clips (see figure 14).

Hold the misting tube secure against the stand pole using
the two clips (see figure 15).
CONNECTING THE GARDEN HOSE
See Figures 16 - 17.
 Completely uncoil the garden hose to prevent kinks.

Run water through the hose for 30 seconds to clean any
debris from the hose.

With the faucet turned completely off, attach the end of
the garden hose to the misting tube coupler. Tighten by
hand.