20
2. Slide the grip onto the handlebar until it is fully
seated with the smooth part of the grip facing up.
NOTE: A quick, firm push is required to seat the
grip completely on the handlebar. Install while the
glue is wet.
3. Wipe off any excess glue; then secure the grip with
the plug, end cap, and cap screw.
Throttle Control
REMOVING
1. Remove the two machine screws securing the throt-
tle control to the handlebar.
2. Slide the grommet out of the lower half of the throt-
tle control; then remove the cable from the actuator
arm.
AF676D
3. Remove the cap screw, lock washer, and washer
securing the actuator arm to the throttle control lever.
AF677D
4. Remove the actuator arm and account for a bushing.
Note the position of the return spring for installing
purposes.
AF678D
INSTALLING
1. Place the return spring into the throttle control; then
place the bushing and actuator arm into position.
Secure with the cap screw, lock washer, and washer.
AF679D
2. Using a pair of needle-nose pliers, place the spring
into position on the actuator arm.
AF680D
3. Place the two halves of the throttle control onto the
handlebar and secure with the two machine screws.
ADJUSTING
To adjust throttle cable free-play, see Periodic Mainte-
nance/Tune-Up.
Summary of Contents for XC 450 2016
Page 1: ...www arcticcat com SERVICE MANUAL www arcticcat com...
Page 119: ...118 NOTES...
