35
3. To decrease air pressure in the
shock, press the black bleed valve
button half way down and hold until
desired pressure is attained.
NOTE: Pressing the button fully
down and releasing it will allow only
a small amount of air to escape
(micro-adjust).
4. To increase air pressure in the shock,
pump until desired pressure is
attained.
5. Remove the pump valve from the
shock air valve.
NOTE: As the pump valve is being
removed from the shock, the sound
of air loss is from the pump hose,
not from the shock.
6. Install the air valve cap onto the
shock.
Lights
For the correct LED headlight and/or
LED taillight/brakelight, see the appro-
priate specifications sheet.
Removing and Installing
Taillight/Brakelight
These models are equipped with an LED
taillight/brakelight. If the LED fails, it
must be replaced.
1. Disconnect the taillight harness con-
nector.
2. Remove the torx-head screws secur-
ing the taillight.
3. Connect the taillight harness connec-
tor; then secure the taillight to the
bracket with the torx-head screws.
Adjusting Headlight Aim
The headlight can be adjusted for vertical
aim of the HIGH/LOW beam. The geo-
metric center of HIGH beam zone is to be
used for vertical aiming.
1. Position the snowmobile on a level
floor so the headlight is approxi-
mately 8 m (25 ft) from an aiming
surface (wall or similar surface).
NOTE: There should be an “aver-
age” operating load on the snowmo-
bile when adjusting headlight aim.
2. Measure the distance from the floor
to midpoint of the headlight.
3. Using the measurement obtained in
step 2, make a horizontal mark on
the aiming surface.
4. Make a vertical mark which intersects
the horizontal mark on the aiming sur-
face directly in front of the headlight.
5. Engage the brake lever lock and start
the engine. Move the headlight dimmer
switch to the HIGH beam position. DO
NOT USE LOW BEAM.
6. Observe the headlight beam aim.
Proper aim is when the most intense
beam is centered on the vertical mark 5
cm (2 in.) below the horizontal mark
on the aiming surface.
0745-813
7. Adjust the headlight using the adjust-
ing screw on the backside of the head-
light using a 4 mm swivel socket and
long extension until correct aim is
obtained. Shut the engine off; then dis-
engage the brake lever lock.
0750-309
Summary of Contents for M 9000 King Cat
Page 7: ...3 Snowmobile Safety Rules...
