Arctic Cat Jaguar Z1, Operator'S Manual

Page: 41 / 56

MAINTENANCE 37
7. Install the housing and secure
with the self-tapping screws
and washers.
8. Place the taillight cover into
position and secure with the
two screws.
Removing Headlight Bulb
„
N OTE : T h e bu l b p o r t i o n o f
headlight is fragile . H AN DLE
WITH CARE. When replacing the
headlight bulb, the bulb assembly
must first be removed from the
housing. Do not touch the glass
portion of the bulb. If the glass is
touched, it must be cleaned with a
dry cloth before installing.
To access the headlight bulbs, use
the following procedure:
1. Release the latches securing
the windshield to the wind-
shield base; then remove the
windshield.
2. Remove the two torx-head cap
screws located to the outside of the
headlight adjustment knobs; then
remove the single torx-head cap
screw from beneath the console
(located between the headlights).
741-505A
3. Remove the cap screw and lock
nut securing the front of the
headlight assembly to the air-
intake silencer.
4. Lift the front of the console
enough to allow the headlight
housing to be removed; then
remove the housing.
5. Remove the bulb from the head-
light housing and disconnect the
wiring harness from the bulb.
741-329A
Installing Headlight Bulb
1. Plug the wiring harness into the
headlight bulb.
2. Insert the bulb into the head-
light housing.
3. Lift the front of the console
enough to allow the headlight
housing to be installed; then
install the housing making sure
the forks of the housing go into
the grommets on top of the air-
intake silencer. Secure with the
cap screw and lock nut.
0741-506
! CAUTION
Do not touch the glass portion
of the bulb. If the glass portion
is touched, it must be cleaned
with a dry cloth before installing.