Arctic Cat Jaguar Z1, Operator'S Manual

Page: 25 / 56

LUBRICATION 21
6. Secure the snowmobile in this
position until the fluid is com-
pletely drained.
7. When the fluid has completely
drained from the gear case, tip
the snowmobile back to the
upright position, remove the
drain adapter, and install and
securely tighten the drain plug;
then remove the check/fill plug.
8. Pour the exact amount (see
Specifications) of Arctic Cat
A C T D r i v e F l u i d i n t o t h e
check/fill hole; then install the
plug. Tighten securely.
9. Install the driven pulley; then
install the drive belt (see Drive
Belt sub-section).
10. Place the left-side access panel
into position on its hinges; then
secure with the hinge retaining
clips. Close the access panel.
„
NOTE: If excessive oil deposits
are noticed, take the snowmobile
to an authorized Arctic Cat Snow-
mobile dealer for service. If not
under warranty, this service is at
the discretion and expense of the
snowmobile owner
.
FRONT SUSPENSION
„
NOTE: Arctic Cat recommends
that Arctic Cat Low-Temp Grease
(p/n 0636-593) be used for this
procedure.
It is very important that the front
suspension is greased on a monthly
basis using low-temperature grease.
The front suspension should also be
greased after trailering the snowmo-
bile on an open trailer. Pump grease
into the spindle grease fitting (both
sides) until grease is noted coming
out of the top and bottom of the
spindle. Wipe excess grease from
the spindle.
741-335A
Pump grease into the upper steering
shaft grease fitting (located on the
r i g h t - s i d e o f t h e s n o w m o b i l e
directly above the forward part of
the upper A-arm) until grease is
noted coming out of the bottom of
the shaft. Wipe excess grease from
the shaft.
0741-440
! CAUTION
It is critical that all of the old
fluid be drained from the gear
case prior to filling with new
fluid.
! CAUTION
Do Not add more or less than
the recommended amount of
drive fluid to the gear case or
damage to the gear case will
occur.